Daktronics PC-2002 Pace Clock System Instrukcja Użytkownika Pobierz pdf (Strona 10)

4 Mechanical Installation

Attach the brackets to the top and bottom of the display. Level the display against the

mounting surface and make a mark through the anchor holes on the bracket with a marker or

heavy pencil. Drill holes in the wall and install anchors at the marked locations. Minimum

steel anchor size is 3/16" diameter (4.7 mm).

2.2 Flush Mounting

The PC-2002 can be flush mounted into a 25.5" x 10.0" hole in the wall using a mounting

bezel. This bezel then attaches to the wall with 6 anchors. Attach the bezel around the display

with 8 screws. Provide power and signal wiring inside the opening and then connect the

power and signal to the display (see Section 3). Drill holes in the wall and install anchors at

the holes in the bezel. Refer to Figure 5:

10.00"

25.50"

Wall anchors and

mounting screws

are not provided

Flush mounting bezel

Wall opening

Figure 5: Flush Mounting Installation

Wall anchors/screws

are not provided

Wall opening

Flush mounting bezel

25.5"

10.0"

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Brak uwag

Daktronics PC-2002 Pace Clock System Instrukcja Użytkownika Strona 10